Weight: 40 lbs
BCI Group 31 footprint. Verify tray dimensions, terminals, wiring and charging-system compatibility before installation.
Recommended Charging Settings:
Maximum Continuous Charge Current: 200A per battery, all charging sources combined
Recommended Charge Current: Up to 86A (0.5C) for one battery; up to 50% of bank capacity for parallel banks (172A for 2P, 258A for 3P, 344A for 4P), within charger, wiring and system limits
Bulk/Absorption: 14.2V-14.6V
Absorption Time: End when current falls to C/20 (about 8.6A) or after 15 minutes, whichever comes first
Float Voltage: Disabled (preferred, where the charger supports it) or 13.4V-13.8V
Re-bulk: 13.2V (if programmable)
Temperature Compensation: 0 mV/°C (disabled)
Equalization: Disabled; do not use lead-acid equalization, desulfation or repair modes
Charge Temperature Range: Program chargers for 0°C to 55°C (32°F to 131°F). The battery is rated to charge from -5°C (23°F), but it has no internal heating, and the BMS blocks charging when it is too cold
BMS High Voltage Cutoff: 14.6V
SoC Recalibration: 14.6V
Maximum Charge Input: 15.0V maximum input rating, not a charger target
Compatible Chargers: 12V LiFePO4 chargers, converters, inverter chargers and solar charge controllers that can be set to the values above; a charger below the recommended 86A is suitable, it simply takes longer
Alternators: use a DC-to-DC charger or lithium-ready regulation where needed, and confirm the outboard or engine maker's charging requirements
NOTE: Not all chargers can do multistage lithium charging. If yours cannot be fully programmed, verify that its bulk/absorption voltage is within range and that equalization and temperature compensation are disabled. Consult the charger manual or manufacturer.