12V 300Ah Group 8D Dual-Purpose LiFePO4 (3.84kWh nominal): Engine cranking plus deep-cycle house power in one BCI Group 8D case, 19.7 × 10.5 × 9.75 in (500 × 267 × 248 mm), 81 lb (36.7 kg).
New Launch
Regular price
$1,599.00
Regular price
$1,599.00
Sale price
$1,599.00
Save:
$0.00
(0% Off)*
Unit price/ per
Sale
Sold out
Shipping calculated at checkout (Free shipping above $100)
Dust-tight and protected against temporary immersion to 1 m for 30 minutes.
6,000+
Cycle life
Over 16 years at one full cycle a day. Rated at the depth of discharge, charge rate and temperature stated on the datasheet, to its end-of-life capacity.
iOS + Android
Bluetooth app
Charge, voltage and temperature on your phone in the Epoch Pro app.
Advanced BMS
Protection
Guards against overcharge, over-discharge, overcurrent and short circuit.
Self-heating
Cold weather
Warms its cells before charging, so it can charge in freezing weather.
LiFePO4
Thermal stability
Lithium iron phosphate has a far lower thermal-runaway risk than other lithium chemistries. The BMS adds over-temperature and low-temperature charge protection.
12V 300Ah Group 8D Dual-Purpose LiFePO4 (3.84kWh nominal): Engine cranking plus deep-cycle house power in one BCI Group 8D case, 19.7 × 10.5 × 9.75 in (500 × 267 × 248 mm), 81 lb (36.7 kg). Not a drop-in replacement for every lead-acid installation: verify tray fit, terminal clearance, cabling, overcurrent protection, charger profile and engine and alternator compatibility.
Cranking Power: 1,000A for up to 5 seconds and 800A for up to 10 seconds, for engine cranking and short start-up surges (tested above 60% state of charge at 25°C). Rated by peak current and duration, not CCA, so verify the engine maker's battery requirements; Epoch cites compatibility with Mercury 250 hp outboards and other leading brands when the engine's battery requirements, alternator, wiring and charging profile are matched.
300A Continuous Output: 300A continuous discharge (150A recommended for daily use) for house loads and 3,000W-class inverter systems (300A is about 3,840W of DC input). Keep enough charge in reserve to start the engine.
Charging: 300A maximum from all sources combined, up to 150A recommended; 14.2V bulk/absorption (14.2-14.6V range), 13.8V float (13.4-13.8V range; off preferred where the charger allows), equalization and temperature compensation disabled. 15.4V is a listed maximum, not a charger target. Use the Epoch 12V 50A Lithium Battery Charger or another LiFePO4 charger, and a DC-to-DC charger or lithium-ready regulation for alternators.
Self-Heating: With a charger connected in cold weather, the internal heating film warms the battery to 10°C (50°F) before charging starts, so it charges from -20°C to 55°C (-4°F to 131°F); it discharges from -20°C to 60°C (-4°F to 140°F).
IP67 Enclosure: Dust-tight and protected against temporary immersion to 1 m for 30 minutes. Not for submersion, water jets or pressure washing. Mount it upright in a dry, ventilated spot where standing water cannot collect (not in a bilge).
Bluetooth: The free Epoch Pro app (iOS and Android) shows state of charge, voltage, current, temperature and status alerts, sets up multi-battery networks and installs firmware updates over the air.
CAN Networking: CAN Link in and Link out ports network a bank and connect external devices; for Victron systems or NMEA 2000 networks, Epoch offers the Pro Series communications box (contact Epoch for configuration support).
Series & Parallel: Up to 4 in series (48V class) or 16 in parallel at 12V (4,800Ah, 61.44kWh); with batteries in series, up to 4 strings in parallel (4S4P maximum: 51.2V, 1,200Ah, 61.44kWh). Use matched DP12300H batteries within 0.5V of each other.
Smart BMS: Overcharge, over-discharge, over-current, short-circuit (cutoff at 1,200A within 500µs) and high/low temperature protection. Install a DC-rated main fuse or breaker close to the positive terminal.
6,000+ Cycles & 11-Year Limited Warranty: 6,000+ cycles (0.2C, 80% DoD, to 80% of initial capacity, 25°C). No watering or acid service; inspect it routinely. 11-year limited warranty; register within 90 days or keep your proof of purchase.
Specifications:
Configuration
Cell Configuration: 4S3P
Chemistry: LiFePO4
Current
Ah Capacity: 300Ah
Max Continuous Discharge Amps: 300A (150A recommended)
Max Charge Current Amps: 300A (150A recommended)
Max Discharge Peak Current Amps: 1,000A (up to 5 Seconds), 800A (up to 10 Seconds)
Series | Parallel: Max (4) in Series, Max (16) in Parallel (4S4P maximum)
Voltage
Voltage: 12.8V
Max Charge Voltage: 15.4V (listed maximum, not a charger target)
BCI Group 8D footprint. Verify tray dimensions, terminals, wiring and charging-system compatibility before installation.
Recommended Charging Settings:
Program every charging source (chargers, inverter chargers, converters, solar charge controllers, DC-to-DC chargers and alternator regulation) for 12V LiFePO4 with these settings.
Float: 13.8V recommended (13.4V - 13.8V range); LiFePO4 does not need float, so float off is preferred where the charger allows it
Equalization: Disabled (no lead-acid equalization, desulfation or repair modes)
Temperature Compensation: 0mV/°C (disabled)
Maximum Charge Current: 300A continuous, from all charging sources combined
Recommended Charge Current: up to 150A for one battery (50% of capacity); up to 50% of bank capacity for banks (2P 300A, 4P 600A, 8P 1,200A, 16P 2,400A)
Maximum Charge Input: 15.4V listed maximum, not a charger target
Absorption Time / End Current: no separate value; if your charger requires one, use the settings above and avoid long lead-acid absorption periods
Charge Temperature: -20°C to 55°C (-4°F to 131°F) with internal heating. With a charger connected below 0°C (32°F), the heater warms the battery to 10°C (50°F) before charging starts; leave the charger connected and allow up to 60 minutes
Discharge Temperature: -20°C to 60°C (-4°F to 140°F)
Compatible Chargers: 12V LiFePO4 chargers such as the Epoch 12V 50A Lithium Battery Charger (a smaller charger is suitable; it simply takes longer); solar charge controllers (MPPT or PWM) with a programmable or LiFePO4 profile; converters and inverter chargers that can be set to these values
Alternators: use a DC-to-DC charger or lithium-ready regulation where the engine maker allows it, and confirm the alternator's temperature, duty cycle and output limits
NOTE: Not all chargers can do multistage lithium charging. If yours cannot be fully programmed, verify that its bulk/absorption voltage is within range and that equalization and temperature compensation are disabled. Consult the charger manual or manufacturer.
Compatibility:
The Epoch Batteries DP12300H (12.8V 300Ah Group 8D Pro Series Dual-Purpose LiFePO4) compatibility and incompatibility breakdown is listed below (no links included):
Compatible With
Engine Starting & Cranking: Dual-purpose rated for 1,000A peak (5 seconds) and 800A (10 seconds)—compatible with marine outboards (up to ~250 HP) and engines whose manufacturer approves lithium cranking batteries within these limits.
12V, 24V, 36V & 48V House & Off-Grid Systems: Marine house banks, RVs, camper vans, overland builds, and solar storage.
Heavy 12V Inverters: Single-battery support for 3,000W-class 12V inverters (300A continuous discharge / ~3,840W DC).
Series & Parallel Expansion: Up to 4 batteries in series (for 24V, 36V, or 48V banks) or up to 16 batteries in parallel at 12V (4,800Ah); maximum 4S4P networked bank using matched DP12300H batteries within 0.5V of each other.
Victron & Marine Networks: Features CAN Link in/out ports for battery-to-battery networking and closed-loop communication with Victron GX systems or NMEA 2000 networks (via the Epoch Pro Series communications box).
Wet & Harsh Marine Environments:IP67 dust-tight and waterproof rating (handles temporary immersion up to 1 meter for 30 minutes).
LiFePO4 Chargers & Cold Weather: Compatible with LiFePO4 AC converters, MPPT solar controllers, and approved engine charging systems (300A max charge); internal heater enables charging down to -20°C (-4°F).
BCI Group 8D Trays: Fits standard Group 8D battery boxes/trays (19.70" L × 10.5" W × 9.75" H, 81 lbs).
Mobile App: iOS and Android devices via the Epoch Pro app (Bluetooth monitoring, network setup, and OTA firmware updates).
Not Compatible With
Engines Disallowing Lithium Starting: Outboard or inboard engines whose OEM manuals strictly prohibit LiFePO4 batteries or exceed the 1,000A 5-second cranking limit.
Unregulated High-Output Alternators: Engines without lithium-compatible voltage regulation or a DC-to-DC charger (BMS high-voltage disconnects can damage unregulated alternators).
Mixed-Model Battery Banks: Cannot be wired in series or parallel with lead-acid batteries or different Epoch models/capacities (such as the 12300A-H or 12334A-H).
Standard Group 31 Trays: Uses a larger BCI Group 8D footprint and will not fit Group 24, 27, or 31 battery boxes.
Add your content here for Tab 1.22
Add your content here for Tab 1.
FEEDBACK
TESTIMONIALS
Choosing a selection results in a full page refresh.
Opens in a new window.
[label]
🔴
[message]
[img]
[title]
[message]
[subMessage]
My Wishlist
Choose email method
Total in Wishlist:[totalPriceWishlist]
Love it? Add to your wishlist
Your favorites, all in one place. Shop quickly and easily with the wishlist feature!