Unlike traditional subwoofers that require messy adhesives, specialized shops, and days of drying time, this competition-grade kit uses Kicker's bolt-on engineering so you can repair your bass right in the field.
📦 What's Included in the Kit
The kit comes as a single, pre-joined structural unit to guarantee that everything is perfectly aligned:
-
Glass Fiber-Reinforced Cone: The exact square pulp paper cone used on the retail speaker.
-
NBR Rubber Surround: The heavy-duty tall border that controls the extreme forward and backward movement.
-
4-Inch Voice Coil: A massive, high-temperature copper coil pre-wound on an aluminum former.
-
Dual-Spider Suspension: The lower fabric springs that keep the movement straight and true.
-
XS Spacing / Alignment Pins: Specialized metal needles used during install to center the voice coil perfectly inside the magnet.
⚡ Key Features & Upgrades
-
Zero Glue Required: The entire moving assembly bolts directly into the aluminum basket and motor layout.
-
Impedance Swapping Freedom: A major feature of the SoloXS lineup is its structural interchangeability. If your amplifier setup changes, you can install this 1-ohm recone kit into a basket that originally held a 2-ohm cone.
-
Cost-Efficient: Instead of discarding a massive 830-ounce magnet and cast basket assembly, you only buy the parts that actually wear out or burn.
🛠️ Overview of the Recone Process
The installation is straightforward and requires standard tools like a 4mm Allen wrench:
-
Remove Old Hardware: Back out the screws on the top face trim ring and the bolts securing the spider landing down inside the frame.
-
Slide Out Damaged Cone: Pull the old, blown cone assembly straight up and out of the basket basket.
-
Clean the Magnet Gap: Use tape or compressed air to ensure no leftover burnt voice coil debris or dust remains inside the deep magnetic slot.
-
Insert Alignment Pins: Turn the speaker on its side and slide the included alignment pins through the Forced Air Cooling vents on the back of the magnet. This creates a protective, centered wall inside the gap.
-
Drop in the New Kit: Slide the new 52L7XS181RK voice coil right over those alignment pins until it seats flush against the frame.
-
Bolt and Tighten: Fasten the bolts down onto the spider landing using an alternating "X" crisscross pattern to keep the tension even.
- Pull Pins & Finish: Slide the alignment needles out from the back of the speaker, put the top cosmetic trim ring back on, and you are ready to bump again.
New Launch
Free shipping Over $99
Sold in last hours
